Weekly Report 15Apr2011: Difference between revisions
Jump to navigation
Jump to search
imported>Agopie (Created page with "===RHESSI Albedo Imaging Test=== RHESSI Clean Imaging techniques were used to image a large number of flares. For each flare three different detector combinations and two differ...") |
imported>Agopie |
||
| Line 22: | Line 22: | ||
[[File:Ratio stdev det1to9.jpg|center|thumb|700px|]] | [[File:Ratio stdev det1to9.jpg|center|thumb|700px|]] | ||
[[File:Ratio stdev det1to5.jpg|center|thumb|700px|]] | |||
[[File:Ratio stddev det6to9.jpg|center|thumb|700px|]] | [[File:Ratio stddev det6to9.jpg|center|thumb|700px|]] | ||
[[File:Ratio 12 25 coarse fine.jpg|center|thumb|700px|]] | |||
====25keV - 50keV==== | ====25keV - 50keV==== | ||
Revision as of 20:10, 18 April 2011
RHESSI Albedo Imaging Test
RHESSI Clean Imaging techniques were used to image a large number of flares. For each flare three different detector combinations and two different energy bands were used. The following parameters were used: The flares used were decided upon by the RHESSI response in the 25keV-50keV bands.
- Time: Decided by the peak of the 25keV-50keV energy band for each flare
- Energy: 12keV to 25keV, or 25keV to 50keV
- Detectors: 1 to 9, or 1 to 5,or 6 to 9
- Pixel Size: 2 arcsec by 2 arcsec
- Image Size: 128 pixels by 128 pixels
- Clean Beam Width Factor = 2
Clean images were made with each for each energy band with each detector combination. For each image the centroid of the source was measured, the total flux in the image was measured, and the standard deviation in the x and y direction for each source was measured. Using these measurements the plots below were made.
